Current:Home > CaseInstallation Notes for Wire Mesh Belt

Important: Remove the old belt and thread the pull-in cable through at the same time.  This cable will be used for installation of the new belt later.  Now, thoroughly clean the entire conveyor and be sure the belt path is clear. Correct any problems that caused damage to the previous belt

Before Installation and again before applying tension to the belt, make sure that none of the spirals are turned up. They should be free to hinge about their proper axis.

During Installation use the pulling cable attached to a yoke or lead in device to pull in the belt.  This insures uniform tension across the full belt width.  Be certain to pull the belt along the center of the conveyor evenly and avoid snagging the edges.


address£ºDa Qi Industrial Park of Ningjin County in Shandong ProvinceA8 Contact person£ºLujing Li The telephone£º0534-5533130 0534-5534558 Fax£º0534-5215738
Mobile phone£º13869240308 Copyright © Ningjin Haofa Chain Co.,Ltd Filing number£ºLUICPBEI12016374HAO-2 Website Design£ºJISU